R&S ESIB-7 Compliant Receiver Analyser

A fully compliant receiver. Testing to: CISPR16-1/VDE0876/EN/FCC/ ANSI/VCCI. And with MIL STD. & DEF. STAN, DO-160 capability. Mains operation, but with no tracking generator (see end of description). Full pre-selection in receiver mode. It comes with the 10dB pre-amp option all the way to 7GHz. It can be used as stand-alone or with our Item 124 laptop + s/w. Special software drivers have been written for this device with multiband capability in that the software allows specific menus to be called up for different ranges, i.e. different bandwidths; antennas; spec lines etc. etc. These are then concatenated together as a single test file. The unit has two modes of operation as either an EMI receiver or as a spectrum analyser.  Two RF inputs (20Hz-1GHz) & (20Hz-7GHz) to accommodate modes of operation. The receiver is also well equipped to carry out the conducted tests as well as the radiated. It is shipped with a DC block connector & the R&S LF transient suppressor for conducted work. Antenna or transducer factors can be stored to provide a composite data display of emissions against spec lines on its own internal print-out facility. A high measurement accuracy typically less than 0.7dB. A choice of 4 parallel detectors Pk.;Av.;Qp.; RMS. EMI Bandwidths of: 200Hz;9kHz;120kHz & Mil.Std’s 10Hz-10MHz requirement.. Brilliant two trace TFT colour display unit.All the microwave cables suited to the microwave end of the Rx can be found in section 700.