Item 955 - Conducted Immunity System (Bespoke)
Conducted Immunity testing involves injecting RF voltages or currents onto the cables to an Equipment Under Test (EUT) to confirm that the RF will not cause degradation of performance or deviation from specifications of the EUT. The test simulates the proximity of the EUT and its connected cables to radio transmitters operating at low frequencies. Injecting low level RF signals and high frequency current into wires and cable bundles are a common requirement in the EMC test world
Equipment
Equipment shall be selected by EMC Hire engineers based on the customer needs, therefore please provide as much information as possible (e.g. applicable standard, test level, size of EUT cables etc) when enquiring.
The injection device can be CDN, EM Clamp, BCI probe, Coupling Transformer depending on the standard.
A monitoring probe can be used, depending on the standard applied, to record the amount of current flowing in the cable under test.
A laptop containing DARE RadiMation test software is included in the system, which will be preloaded with the appropriate test configurations including transducer factors. A software operating procedure is also included to guide you through using the software
Calibration
Due to large variations of circuit impedances and resonances in cables, a calibration is performed to establish the forward power into the injection device required to develop the required test level. This is stored in the software for playback onto the EUT.
If required, the conducted immunity calibration can be performed by EMC Hire prior to the hire.
Test Support
EMC Hire can provide an Engineer to set up the system at your location if required, or can offer remote assistance via Teamviewer or Teams.
Standards
Standards that can be provided include:
- EN 61000-4-6
- ISO 11452-4 / SAE J1113-4 / Ford / JLR / DC / GM and other OEMs
- Mil Std 461
- Def Stan 59-411
- Def Stan 61-5 – DIT03.A
Item 955 - Conducted Immunity System (Bespoke)
Specifications
Frequency Range |
Dependent on test method |
System comprises: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Laptop with Control Software, including all necessary ancillaries |
|
In response to your enquiry via phone or through this website, an engineer will contact you to discuss your requirements. We advise that you download the below Test Systems Enquiry Form to expedite the process and ensure that your requirements are fully understood and met.
Test Systems Enquiry Form Download
Complete the form filling in all of the information you have about your test requirements and Equipment Under Test and submit to our team of technical specialists at Support@emchire.co.uk and we will contact you to discuss your requirements and time frames.