MilMega 80RF1000-250 Watt.

EMC Item no.: 414
Category:
  • ISO 11451-X
  • ISO 11452-x
  • Regulation 10
  • DEF STAN 59-411
  • EN-61000-4-3 : Immunity
  • RF Amplifiers & Pre-Amps
  • RF Amplifiers DC - 1 GHz
Test Mode: Immunity
Manufacturer: Milmega
Frequency: 80MHz-1GHz

Product description

A new member to the radiated spectrum of ampliifers. With 200 watts nominal output this amplifier will be well suited to carry out work for EN61000-4-3 up to 1GHz. For its power handling it is incredibly light at 30kgm. High visabilty status indicator for forward and reflected power and other data. Single phase mains input required 85-260vac, 47-65Hz. 2kVA approx. The harmonic distortion is: -20dBc. Gain variation is+ - 3dB. Noise Figure: 10.0 dB max.

General specification

Gain: 51dB

O/P: 150Watts min.

Input drive: 1mW (0dBm) max

O/P Impedance: 50 Ω

O/P VSWR:2:1

Connectors: BNC i/p & N o/p.

Power Req: 240vac, 10.5A Single phase.

Size: 51cm x 34cm x 46cm

Weight: 64kg

80 to 1000 MHz

Minimum Psat Minimum P1dB
Pow   170W           170 W
System Parameters

                   Nominal Minimum Maximum
Harmonics at  P1dB    -20 dBc   -15dBc
Gain              62 dB    58 dB      70dB
Gain variation with frequency +/- 3.5 dB
Noise figure 10.0 dB
Input Power (no damage) +10 dBm
Output VSWR tolerance Infinite any phase
Stability Unconditional
Output impedance 50 Ohm
Output VSWR 2:1
Input VSWR 2:1
Third order intercept point IP3 8dB > P1dB
Spurious -80 dBc
Safety interlock via rear panel D-sub connector
Supply Voltage 100 to 240 VAC
Supply Frequency 47 to 63 Hz
Supply Power 1.5 kVA (typical full power)
RF Input Type N female
RF Output Type N female
Dimension 19 inch, 3U case, 582mm Deep
Weight 22 kg