Model 6403 90cm Helmholtz coil system has twin coils and is normally used as a magnetic field immunity test system. A magnetic field is produced by two coils that is essentially homogenous throughout the volume between the face of the coils and one-third diameter of the coils at it’s centre. The coils are supported by a non-metallic framework. A rotating, height-adjustable pedestal is capable of holding articles weighing up to 34kg. The Coil has been initially calibrated at the NPL in terms of uT/amp at 50Hz. For the end user’s convenience NPL have also quoted a figure of uTesla per millivolt as measured across an installed shunt resistor with measuring terminal placed at the base of the Helmholtz. This was done at 60Hz and 2kHz. Built in on the base is the feed connector.

EMCH 6403-2 Helmholtz Coil 90cm Diameter 30 Turns

Added to your quote.

Item Number: 313
Category: DEF STAN 59-411
Test Mode: Immunity
Test Type: Radiated
Manufacturer: EMC Hire
Frequency: 20Hz-2kHz

Product Downloads

Manuals, datasheets and handbooks for EMCH 6403-2 Helmholtz Coil 90cm Diameter 30 Turns are available to registered users.

General Specification

Coil Diameter: 90cm

Freqency range: DC to 2kHz

Coil Factor: 118.7 uTesla/ampere

Homogeneity: ±5% within a 30cm cube

Coil Impedance: Approx. 0.5ohms DC;

Inductance: 18.4 millihenrys

Self Resonance: 18kHz

Max I Input: 15 amps continuous

EMC Hire newsletter

A practical weekly update for engineers, technicians and anyone working with EMC testing. Receive useful guidance, technical articles and real-world lessons directly from EMC Hire.

Technical guidance

Practical EMC testing advice and useful engineering explanations.

EMC Banana Skins

Real-world mistakes, unexpected problems and lessons worth sharing.

One email a week

A concise weekly roundup with no unnecessary noise.

Join The Weekly Signal

Enter your email address and confirm your subscription from your inbox.

We use double opt-in to confirm your subscription. You can unsubscribe at any time. See our privacy policy .