Skip to content
Logo
This is usually accomplished using and R&S Spectrum Analyser under laptop computer control with EMCH software. This will entail a rod antenna from 10kHz-30MHz following on with a Bilog from 30MHz-1-5GHz. Horns would then be used on up to a higher microwave frequency. Upper frequency ranges will be done in both vertical and horizontal polarizations. A peak hold facility is available with the Analyser to capture intermittent signals over a specified period of time. Variations on the itinerary can be discussed upon number of locations to be tested and the duration of the sweep periods. A petrol generator can be used where there is no mains available. This service is often used where there are possible Health and Safety issues. A report is submitted
The Weekly Signal

EMC Hire newsletter

The Weekly Signal

A practical weekly update for engineers, technicians and anyone working with EMC testing. Receive useful guidance, technical articles and real-world lessons directly from EMC Hire.

Technical guidance

Practical EMC testing advice and useful engineering explanations.

EMC Banana Skins

Real-world mistakes, unexpected problems and lessons worth sharing.

One email a week

A concise weekly roundup with no unnecessary noise.

Join The Weekly Signal

Enter your email address and confirm your subscription from your inbox.

We use double opt-in to confirm your subscription. You can unsubscribe at any time. See our privacy policy .